ATS Products

The DIY (“Do It Yourself”) family of high-performance cold plates provides engineers with the freedom to drill holes to match the specific connection points of the devices being cooled such as IGBT, MOSFET, or other power electronics. Each cold plate has an etched “no drill zone” to provide a visual guide.

Outside of the “no drill zone,” through holes can be drilled at any point. (Avoid drilling into the I/O ports.) Inside the “no drill zone” holes can only be drilled to a depth of 6 mm to avoid damaging the internal fin field. (See explanatory graphic below).


All ATS standard IGBT cold plates have unmatched thermal performance because of their mini-channel fin design.

The ATS-CP-1002-DIY has the same thermal performance as the ATS-CP-1002., at a flow rate of 4 L/min, can transfer 1kW of heat at 7°C temperature difference between the cold plate base and inlet fluid temperature. If the coolant has particles, a #60 filter or finer is recommended to remove possible particles in the liquid.

Customization is available. ATS can design cold plates to meet size restrictions and manufacture cold plates to connect with a variety of components include


  • Dimensions in mm (L x W x H): 162 x 136 x 20
  • Material: Aluminum (Unfinished)
  • Weight: 1,102 grams
  • More than 30% improvement in thermal performance compared to commercially-available cold plates
  • Compatible with industry accepted coolants
  • 1/4 (pipe size) – 18 (thread density) NPT threaded input and output
  • Low pressure drop characteristics
  • Lightweight for ease of use
  • Provides uniform cold plate surface temperature when IGBTs are installed
  • Maximum Pressure: 60 psi
  • Customizable to fit different devices
Part Number Lifecycle Status Plate Dimension (mm) Weight
Thermal Base on 1kW
& Flow Rate of 4 L / min
Material Data Sheet RoHS & REACH
Length Width Height
ATS-CP-1002-DIY ACTIVE 162.0 136.0 20.0 1,102 N/A Aluminum download data sheet
Thermal Performance
Schematic Image Thermal Resistance
Flow Rate
kPA (psi)

*Image above is for illustration purpose only.
1.9(0.5) 7 0.00 (0.00)
3.7(1.0) 0 0.00 (0.00)
5.7(1.5) 0 0.00 (0.00)
7.6(2.0) 0 0.00 (0.00)
ATS-CP-1002-DIY   (Data Sheet)
download data sheet
Mechanical Drawing - FUSED MODEL (used for Form and Fit use)
download fused Model for Form and Fit use
Obtain RoHS Certificate
download data sheet